謝各位先進幫我把問題找出來,原來它的說明書有兩份,我下載了最新那份,所以沒發覺! ><
reset 3com 3crwe554G72T 以及 3CRWEG72TU至factory default
步驟如下
step1
切斷電源
step 2
拔除所有在router的連接cable
step 3
使用一組網路線連接一邊連接"wan port",另一頭連接lan port (都是在router端)
step 4
重新接上電源,等上約1分鐘(等待alert紅燈以很慢的速度閃爍,表示完成),再將電源拔掉
step 5
拔掉網路端,重新接上一台電腦來連線! (電腦端設自動取得ip)
step 6
重新插上電源
step 7
登入
http://1921.168.1.1 perfect!
原文如下
1 Remove power from the Router.
2 Disconnect all your computers and the cable/DSL modem from the Router.
3 Using a straight through Ethernet cable, connect the Ethernet Cable/DSL port on the rear of the Router to any one of the LAN ports.
4 Re-apply power to the Router. The Alert LED will flash as the Router starts up, and after approximately 30 seconds will start to flash more slowly
(typically 2 seconds on, 2 seconds off). Once the Alert LED has started toflash slowly, remove power from the Router.
5 Remove the cable connecting the Cable/DSL port to the LAN port, andreconnect one of your computers to one of the Router LAN ports.
6 Re-apply power to the Router, and when the start-up sequence has
completed, browse to:
http://192.168.1.1